公司新聞

裝載機使用之前先來了解這些故障！

來源：http://m.seatostar.com/ 日期：2023-06-09

裝載機是工程機械中比較常用到的一種，價格也比較高，在使用的時候需要注意維修保養，一旦發現問題，需要及時的進行維修處理。在這里濟南裝載機租賃廠家給大家介紹下操作裝載機的時候常遇到的一些故障和解決方法。

Loaders are a commonly used type of construction machinery and have a relatively high price. When in use, attention should be paid to maintenance and repair. Once problems are found, they need to be promptly repaired and dealt with. Here, Jinan loader rental manufacturer will introduce some common faults and solutions encountered when operating loaders.

一、突然不能正常工作

1、 Sudden malfunction

裝載機在工地施工時，突然不能正常工作也是比較常見的問題，會影響到正常的施工進展，有可能是發動機突然熄火了，動力不足了，或者是轉向沉重。

It is also a common problem for loaders to suddenly fail to work properly during construction on the construction site, which can affect normal construction progress. It may be due to sudden engine shutdown, insufficient power, or heavy steering.

二、操作的時候有異常的聲音發出

2、 Abnormal sound emitted during operation

裝載機有異常的聲音發出，造成這一現象的原因有很多，比如發動機出現故障了，變速箱或是變矩器，液壓系統出現問題啦，當聽到有異常聲音發出的時候，應該立馬停機檢查。

There are many reasons for the abnormal sound emitted by the loader, such as engine malfunction, gearbox or torque converter, or hydraulic system problems. When an abnormal sound is heard, it should be immediately stopped for inspection.

三、裝載機過熱現象

3、 Overheating phenomenon of loader

裝載機出現過熱的現象在夏季的時候更容易出現，發動機，變數箱，制動器，驅動橋上溫度過高的現象比較明顯。如果是發動機過熱的話，裝載機的冷卻系統可能存在問題。

The phenomenon of overheating in loaders is more likely to occur in summer, and the phenomenon of excessive temperature on the engine, variable gearbox, brakes, and drive axle is more obvious. If the engine overheats, there may be a problem with the cooling system of the loader.
濟南裝載機租賃

四、裝載機存在滲漏現象

4、 There is leakage in the loader

滲漏現象也是比較常出現的問題，同其他故障相比，一般這種現象比較好觀察到，出現滲透問題的可能是裝載機內添加的燃油、液壓油、潤滑油等。一旦發現這種問題，應該盡早的更換配件，及時制止。

Leakage is also a common problem, and compared to other faults, this phenomenon is generally easier to observe. The problem of leakage may be caused by fuel, hydraulic oil, lubricating oil, etc. added to the loader. Once this problem is discovered, it should be replaced with accessories as soon as possible and stopped in a timely manner.

五、裝載機排除的煙的顏色不太正常

5、 The color of the smoke discharged by the loader is not very normal

正常工作時，裝載機排除的都?xì)怏w的主要成分是少量的水蒸氣和二氧化碳，如果裝載機出現故障的話，尤其是發動機出現問題的話，排除的氣體中可能存在碳粒、氧化氫、一氧化碳或大量的水蒸氣。

During normal operation, the main components of the gas discharged by the loader are a small amount of water vapor and carbon dioxide. If the loader malfunctions, especially if the engine has problems, there may be carbon particles, hydrogen oxide, carbon monoxide, or a large amount of water vapor in the discharged gas.

六、裝載機燃料/潤滑油的量消耗不正常

6、 Abnormal consumption of fuel/lubricating oil in the loader

如果在使用裝載機施工的時候發現裝載機的油耗量比較大，這種故障發生可能是裝載機的液壓傳動系統、制動系統出現問題了，需要找專業的維修服務人員幫助維修服務。

If it is found that the fuel consumption of the loader is relatively high during construction, this fault may occur due to problems with the hydraulic transmission system and braking system of the loader. Professional maintenance service personnel need to be sought to assist in maintenance services.

每次在使用裝載機之前都要仔細檢查，一旦發現有故障，需要立馬停機檢查維修。更多相關事項就來我們網站http://m.seatostar.com咨詢！

Before using the loader, it is necessary to carefully inspect it. Once a malfunction is found, it needs to be immediately stopped for inspection and repair. For more related matters, come to our website http://m.seatostar.com consulting service

上一條：公路工程瀝青混凝土的路面接縫處理技術

下一條：攤鋪機工作前和工作時的注意事項