生產加工嚴守質量關卡

Strict adherence to quality standards in production and processing

一、原材料精挑細選

1、 Carefully selected raw materials

在濟南，水泥穩定碎石生產企業對原材料質量嚴格把控。水泥多選用初凝時間大于 3h、終凝時間不小于 6h 的 32.5 級或 42.5 級普通硅酸鹽水泥、礦渣硅酸鹽水泥或火山灰質硅酸鹽水泥，確保在施工過程中有足夠的操作時間，且水泥硬化后能提供穩定的粘結強度。碎石要求質地堅硬、潔凈、無風化顆粒，壓碎值不大于 30%，針片狀顆粒含量不超過 20%，顆粒級配符合相關規范。例如，山東匯達新型建筑材料有限公司，作為濟南路面專業化施工骨干企業，在生產水泥穩定碎石時，選用的水泥碎石完全符合現行國家和有關行業標準，從源頭上保障了產品質量。

In Jinan, cement stabilized crushed stone production enterprises strictly control the quality of raw materials. Cement should be selected from 32.5 or 42.5 grade ordinary Portland cement, slag Portland cement, or volcanic ash Portland cement with an initial setting time greater than 3 hours and a final setting time of not less than 6 hours, to ensure sufficient operating time during construction and to provide stable bonding strength after cement hardening. Gravel requires a hard, clean, and non weathered particle texture, with a crushing value of no more than 30%, a needle like particle content of no more than 20%, and a particle grading that meets relevant specifications. For example, Shandong Huida New Building Materials Co., Ltd., as a backbone enterprise in specialized pavement construction in Jinan, uses cement stabilized crushed stone that fully complies with current national and relevant industry standards when producing cement stabilized crushed stone, ensuring product quality from the source.

二、生產工藝精細控制

2、 Fine control of production process

采用集中廠拌的方式生產水泥穩定碎石，配備先進的強制式攪拌機。在生產過程中，依據精確的配合比設計，通過電子計量系統精準控制水泥、碎石、水及外加劑的用量，確?；旌狭系木鶆蛐院头€(wěn)定性。同時，嚴格控制含水量，一般較最佳含水量略高 0.5% - 1.0%，以補償施工過程中的水分損失。如濟南部分大型攪拌站，擁有 800 型雙拌鍋水穩拌和站，年生產能力可達 300 萬噸，月最大供貨能力達 30 萬噸，憑借先進設備與精細工藝，生產出的水泥穩定碎石強度高、和易性好、離析現象少。

Cement stabilized crushed stone is produced using a centralized factory mixing method, equipped with advanced forced mixers. In the production process, based on precise mix design, the amount of cement, crushed stone, water, and additives is accurately controlled through an electronic metering system to ensure the uniformity and stability of the mixture. At the same time, the moisture content is strictly controlled, generally slightly higher than the optimal moisture content by 0.5% -1.0%, to compensate for the moisture loss during the construction process. Some large-scale mixing plants in Jinan have 800 type double mixing pot water stable mixing plants, with an annual production capacity of up to 3 million tons and a maximum monthly supply capacity of 300000 tons. With advanced equipment and fine technology, the cement stabilized crushed stone produced has high strength, good workability, and less segregation phenomenon.

三、施工流程

3、 Construction process

使用大噸位自卸汽車運輸混合料，車輛全程覆蓋篷布，防止水分蒸發和沿途揚塵，確?；旌狭闲阅芊€(wěn)定。到達施工現場后，采用攤鋪機進行攤鋪?zhàn)鳂I(yè)。攤鋪前，精確調整攤鋪機參數，包括熨平板寬度、仰角、工作速度等，保障攤鋪厚度均勻、表面平整。在春陽路貫通道路工程三標段施工中，為保證平整度，采用攤鋪機聯機鋪筑，下基層掛鋼絲繩，上基層走平衡梁，且嚴格控制攤鋪速度在 2 - 3m/min，勻速前進，避免中途停頓或變速，有效減少了施工質量缺陷。

Use large tonnage dump trucks to transport the mixture, and cover the entire vehicle with tarpaulin to prevent moisture evaporation and dust along the way, ensuring stable performance of the mixture. After arriving at the construction site, use a paver for paving operations. Before paving, accurately adjust the parameters of the paver, including the width, elevation angle, and working speed of the ironing board, to ensure uniform paving thickness and smooth surface. In the construction of the third section of the Chunyang Road through road project, in order to ensure flatness, a paver was used for joint paving. Steel wire ropes were hung on the lower base layer, and a balance beam was used on the upper base layer. The paving speed was strictly controlled at 2-3m/min, moving at a constant speed to avoid stopping or changing speed midway, effectively reducing construction quality defects.

本文由濟南水泥穩定碎石友情奉獻.更多有關的知識請點擊:http://m.seatostar.com我們將會對您提出的疑問進行詳細的解答，歡迎您登錄網站留言.

This article is dedicated to friendship For more information, please click: We will provide detailed answers to your questions. You are welcome to log in to our website and leave a message