1、起步前應觀察機前后有無障礙物和行人，將鏟斗提升離地面500毫米左右，鳴喇叭方可起步。行駛中，應視其道路情況，可選用高速檔，在行駛中嚴禁進行升降和翻轉鏟斗動作。

1. Before starting, observe for obstacles and pedestrians in front and behind the machine. Lift the bucket about 500 millimeters above the ground and honk the horn before starting. During driving, depending on the road conditions, high speed gear can be selected, and lifting and flipping bucket actions are strictly prohibited during driving.

2、作業時，應選用低速檔。行走時，盡量避免將鏟斗舉升過高。應根據不同的土質，采用不同的鏟掘方式，盡量從正面插入，防止鏟斗單邊受力。在松散不平的場地作業，可把舉升桿放在浮動位置，使鏟斗平地作業。

2. When doing homework, low gear should be selected. When walking, try to avoid lifting the bucket too high. Different excavation methods should be adopted according to different soil types, and the bucket should be inserted from the front as much as possible to prevent unilateral force on the bucket. When working on a loose and uneven site, the lifting rod can be placed in a floating position to make the bucket level for operation.

3、行駛道路應平坦，不得在傾斜度超過規定的場地上作業，運送距離不宜過大。鏟斗滿載運送時，鏟斗應保持在低位。

3. The driving road should be flat, and operations should not be carried out on sites with an inclination exceeding the specified value. The transportation distance should not be too large. When the bucket is fully loaded for transportation, the bucket should be kept low.

4、在松散不平的場地作業，可將鏟臂放在浮動位置，使鏟斗平穩地推進。如推進阻力過大，可稍稍提升鏟臂，裝料時鏟斗應從正面低速插入，防止鏟斗單邊受力。

4. When working on loose and uneven terrain, the shovel arm can be placed in a floating position to allow the bucket to advance smoothly. If the pushing resistance is too high, the shovel arm can be slightly raised. When loading, the bucket should be inserted at low speed from the front to prevent unilateral force on the bucket.

5、向運輸車輛上卸土?xí)r應緩慢，鏟斗應處在合適的高度，前翻和回位不得碰撞車廂。

5. When unloading soil onto transport vehicles, it should be done slowly, the bucket should be at the appropriate height, and flipping and returning should not collide with the carriage.

6、應經常注意機件運轉聲響，發現異響應立即停車排除故障。當發動機不能運轉需要牽引時，應保持各轉向油缸能自由動作。

6. Regular attention should be paid to the sound of machine operation, and any abnormal response should be immediately stopped to troubleshoot. When the engine cannot run and traction is required, each steering cylinder should be kept free to move.

7、鏟土(料)時，不得采用加大油門，將鏟斗高速猛沖插入土(料)堆的方式進行裝料，應用低速插入將斗底置于平行地面，然后下降鏟臂，順著地面逐漸提高發動機轉速向前掘進，同時卷取土(料)以減輕鏟斗所遇阻力。

7. When shoveling soil (material), it is not allowed to increase the throttle and insert the bucket into the soil (material) pile at high speed for loading. The bucket bottom should be placed parallel to the ground using low-speed insertion, and then the shovel arm should be lowered. The engine speed should be gradually increased along the ground to excavate forward, and the soil (material) should be rolled up to reduce the resistance encountered by the bucket.

8、卸載時，應用離合器踏板制動，使鏟斗前翻不碰車箱為宜，卸料應緩慢，以減輕對車箱的沖擊。鏟臂向上或向下動作大限度后，應將操縱桿很快回到中立位置，以免在安全閥作用下發出噪音和引起各部故障。

8. When unloading, it is advisable to apply the clutch pedal brake to prevent the bucket from flipping forward and touching the car body. The unloading should be done slowly to reduce the impact on the car body. After the shovel arm moves up or down to the maximum extent, the control lever should be quickly returned to the neutral position to avoid making noise and causing various malfunctions under the action of the safety valve.

9、行走轉向時，應盡量緩慢轉彎，應采用制動踏板減速，嚴禁溜坡。經常注意各儀表和指示信號的工作情況，注意察聽發動機及其它各部的工作聲音，發現異常現象，應立即停車檢查，待故障排除后，方可繼續工作。

9. When turning while walking, try to turn slowly and use the brake pedal to slow down. It is strictly prohibited to slide on slopes. Regularly pay attention to the operation of various instruments and indicator signals, pay attention to the working sound of the engine and other parts, and if any abnormal phenomena are found, stop the vehicle immediately for inspection. Only after the fault is eliminated can work continue.

10、停機后，裝載機應選擇堅硬的地面停放，若在坡道上停放時，輪胎前后應用三角木楔住。作業停止后，應將鏟斗放在地面上，將滑閥手柄放在空檔位置，拉好手制動器。

10. After shutdown, the loader should be parked on a hard surface. If parked on a slope, the tires should be wedged in front and behind with triangular blocks. After the homework is stopped, the bucket should be placed on the ground, the slide valve handle should be placed in neutral position, and the handbrake should be pulled properly.